DESCRIPITION

Downward "drooping" of the paint film immediately after application resulting in an uneven coating.

POSSIBLE CAUSE

• Application of too heavy a coat of paint.
• Application in excessively humid and/or cool conditions.
• Application of over thinned paint.
• Painting over a surface contaminant.

SOLUTION

• If paint is still wet, immediately brush out or reroll to redistribute the excess evenly.
• If the paint has dried, sand and reapply a new coat of paint.
• Do not thin the paint unless recommended on the label or data page.
• Follow label and data page directions for the appropriate environmental conditions for the coating.
• Send glossy surfaces dull to provide a profile for the coating to adhere to.
• Follow label and data page directions for the appropriate spreading rate for the product. Two coats of paint at the recommended spread rate are better than one heavy coat.

SYSTEM

INTERIOR

Suggested Finishes Reapply the same or an upgrade coating.

EXTERIOR

Suggested Finishes Reapply the same or an upgrade coating.